This Corroded Hot Water Heater is Beyond Repair
Water heaters are a modern convenience that makes our lives a little better and a lot easier by bringing clean, hot water to our fingertips. Even though we use them almost daily, most people have little working knowledge of this appliance, and even less knowledge of what to do with them when things go wrong, like an untimely cold shower early in the morning. While it’s always best to call a reliable plumber to handle your water heater problems, learning a little bit about what could be the problem can give you a whole new appreciation on the magic your repairman works to get your shower nice and hot again.
For starters, most households will either have a large gas or electric water heater for mass hot water storage, although there are also smaller “on demand” systems which are located right next to the applicable faucet or nozzle. Each of these will have different repair procedures and maintenance requirements, but there are plenty of water heater repairs that can be solved by your plumber with just a few simple tweaks without having to buy a new system. Rusty water
Water tanks need an anode rod, also known as a sacrificial rod, to prevent rust from building up internally. The rod will dissolve over time and needs to be replaced periodically. If your water becomes rust colored, this is typically what’s causing the problem.
Our Water Heater Technicians also Service Commercial Water Boilers Leaks
Overheating of the water temperature and pressure valve is a common reason for leaks. It is often necessary to replace the pressure valve. Unfortunately, if the leak can be described as rusty water at the bottom of the tank, it might be time for a whole new tank.Stinky water
If your water takes on a sulfur-like smell (basically like rotten eggs) you might have a bacterial infection inside of the tank. These bacteria are feeding on the hydrogen gas which is a result of the anode rod. In these cases, it’s usually necessary to drain the entire system, rinse it with a disinfecting solution, and replace the zinc alloy rod and the anode rod.
Corroded Heating Elements from an Electric Water Heater – No hot water
For electric water heaters, the heating element of your tank will need to be fixed or replaced to correct this jolting problem. For gas heaters, this can be as simple as relighting the pilot light, but if the flame keeps going out, the gas pilot control valve is broken. However, if the flame stays on and there’s still no hot water, a new gas thermocouple should do the trick. For an electric water heater, the upper heating element or thermostat will usually be the culprit for why the water’s not hot and need to be changed by your plumber. Whining or popping noises
When sediment builds up in the bottom of the tank, it can cause the water to boil. The tank will need to be flushed and the heating elements cleaned before refilling it.
While a water heater repair sounds relatively simple, it is never as easy as it seems. Incorrectly flushing your system or buying
the wrong valve can change a simple fix by your handy man into an expensive disaster.
In order to save yourself from a huge headache, too many visits to the hardware store, and potentially lots of money, it is always wise to call a reliable plumber to take care of any problems that you’re having with your home’s water heating system.
For more Info visit this @ website
Leaks
Mineral Deposits